The LM410 is the same as the LM400 with the exception of an antenna.
- Check the software version number of your module.
- If 6.18/6.19 then it should have flow control enabled. So when connecting TX/RX lines you need to connect the CTS and RTS lines as well.
- Version 6.64/6.61/6/57 has default flow control disabled and will only work with TX/Rx /GND line connection.
- If specific software is required where the default settings are Resp-, Echo-, then the LM149 cannot be used directly. The LM149 works properly if the test module has Resp+, Echo+ settings.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article